LIGHTING
}}
139
Limitations for active main beam
The camera sensor on which the function is
based has limitations.
If this symbol is shown in the driver dis-
play, together with the message
Active
High Beam Temporarily
unavailable, then switching between
main and dipped beam must be performed man-
ually. The rotating ring on the stalk switch can still
be in the
position. The symbol extin-
guishes when these message are shown.
The same applies if this symbol is
shown together with the message
Windscreen sensor Sensor
blocked, see Owner's manual.
Active main beam may be temporarily unavailable
e.g. in situations with dense fog or heavy rain.
When active main beam becomes available again,
or the windscreen sensors are no longer blocked,
the message goes out and the
symbol illu-
minates.
WARNING
Active main beam is an aid for using the opti-
mum beam pattern when conditions are
favourable.
The driver always bears responsibility for man-
ually switching between main and dipped
beam when traffic situations or weather con-
ditions so require.
Related information
•
Lighting control (p. 134)
•
Using main beam (p. 137)
•
Limitations for camera unit (p. 322)
Using direction indicators
The car's direction indicators are operated with
the left-hand stalk switch. The direction indicator
lamps flash three times or continuously, depend-
ing on how far up or down the stalk switch is
moved.
Direction indicators.
Short flash sequence
Move the stalk switch up or down to the first
position and release. The direction indicator
lamps flash three times. The function can be
activated/deactivated via the centre display.
To Next Page
