Volvo XC40 - Change between Cruise Control and

DRIVER SUPPORT
* Option/accessory.
292
Limitations for Adaptive Cruise
Control
Adaptive cruise control (ACC
48
) may have limita-
tions in certain situations.
Steep roads and/or heavy load
Bear in mind that the adaptive cruise control is
primarily intended for use when driving on level
road surfaces. The function may have difficulty in
keeping the correct distance from the vehicle
ahead when driving on steep downhill slopes - in
which case, be extra attentive and ready to brake.
•
Do not use adaptive cruise control if the car
has a heavy load or a trailer is connected to
the car.
Miscellaneous
•
Drive mode
Off Road cannot be selected
when the adaptive cruise control is activated.
NOTE
The function uses the car's camera unit,
which has some general limitations, see the
"Limitations for camera unit" section.
NOTE
The function uses the car's radar unit, which
has some general limitations, see the section
"Limitations for radar unit".
Related information
•
Adaptive Cruise Control* (p. 281)
Change between Cruise Control
and Adaptive Cruise Control
In a car with Adaptive Cruise Control (ACC
49
)
the driver can change between Cruise Control
(CC
50
) and ACC.
A symbol in the driver display shows which cruise
control is active:
CC ACC
A A
Cruise control Adaptive cruise control
A
WHITE symbol: Function active, GREY symbol: Standby mode
Changing from ACC to CC
Proceed as follows:
1. Set adaptive cruise control to standby mode
using steering wheel button .
2.
Press the
Cruise Control button in the cen-
tre display's function view - the button's indi-
cator changes colour from GREY to GREEN.
> The symbol in the driver display changes
from
ACC to CC. Adap-
tive Cruise Control is now switched off
and Cruise Control is set to standby
mode.
48
Adaptive Cruise Control