EasyManua.ls Logo

Volvo XC40 - Conditions for the Start;Stop Function

Volvo XC40
646 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
STARTING AND DRIVING
}}
421
Conditions for the Start/Stop
function
For the Start/Stop function to work requires that
a number of conditions are met.
If any condition is not met, this will be indicated in
the driver display.
The engine does not auto-stop
The engine does not auto-stop in the following
cases:
•
The car has not reached approx. 10 km/h
(6 mph) after starting.
•
After a number of repeated auto stops,
speed must again exceed approx. 10 km/h
(6 mph) before the next auto stop.
•
The driver has unfastened the seatbelt.
•
The capacity of the starter battery is below
the minimum permissible level.
•
The engine is not at normal operating tem-
perature.
•
The ambient temperature is under -5 °C (23
°F) or above approx. 37 °C (98 °F).
•
the windscreen's electric heating is activated.
•
The environment in the passenger compart-
ment deviates from the set values.
•
the car is reversed.
•
The starter battery's temperature is below or
above the permitted limit values.
•
The driver makes sweeping steering wheel
movements.
•
The road is very steep.
•
The bonnet is opened.
•
When driving at high altitudes when the
engine has not reached operating tempera-
ture.
•
The ABS system has been activated.
•
In the event of heavy braking (even without
the ABS system having been activated).
•
Many starts during a short period of time
have activated the starter motor's thermal
protection.
•
The exhaust system's particulate filter is full
5
.
•
A trailer is connected electrically to the car’s
electrical system.
•
The gearbox is not at normal operating tem-
perature.
•
The gear selector is in M (
±
) position.
The engine does not auto-start
In the following cases the engine does not auto-
start after having auto-stopped:
•
The driver is unbelted, the gear selector is in
P position and the driver's door is open - a
normal start must take place.
The engine auto-starts without the
brake pedal having been released
In the following cases, the engine auto-starts
even if the driver does not take his/her foot off
the brake pedal:
•
High humidity in the passenger compartment
forms misting on the windows.
•
The environment in the passenger compart-
ment deviates from the set values.
•
There is a temporarily high current take-off
or starter battery capacity drops below the
lowest permissible level.
•
Repeated pumping of the brake pedal.
•
The bonnet is opened.
•
The car starts to roll or increase speed
slightly if the car auto-stopped without being
completely stationary.
•
The driver's seatbelt buckle is opened with
the gear selector in D or N position.
•
The gear selector is moved from D to R or M
(±) position.
•
The driver's door is opened with the gear
selector in D position - a "ping" sound and
text message indicate that the ignition is on.
5
Applies to cars with diesel engines.

Table of Contents