Volvo XC40 - Using Homelink

STARTING AND DRIVING
}}
* Option/accessory.
459
www.youtube.com/HomeLinkGentex or call the
toll-free number 00 8000 466 354 65 (or the
toll number +49 6838 907 277)
22
.
Reprogramming individual buttons
To reprogram an individual HomeLink
®
button,
proceed as follows:
1. Press the desired button and hold it
depressed for approx. 20 seconds.
2.
Once the indicator lamp on HomeLink
®
starts to flash slowly, programming can con-
tinue as normal.
Note: If the button to be reprogrammed is
not programmed with a new unit, it will
resume the previously saved programming.
Resetting the HomeLink
®
buttons
It is only possible to reset all of the HomeLink
®
buttons at the same time, not each button indi-
vidually. Individual buttons can only be reprogram-
med.
–
Press and hold depressed the outer buttons
(1 and 3) on HomeLink
®
for approx. 10 sec-
onds.
> When the indicator lamp changes over
from a constant glow to starting to flash,
the buttons are reset and ready to be
reprogrammed.
Related information
•
Using HomeLink (p. 459)
•
HomeLink
®
* (p. 457)
•
Type approval for HomeLink
®
* (p. 460)
Using HomeLink
When HomeLink
®
is fully programmed it can be
used in place of the separate original remote
controls.
Depress the programmed button. The garage
door, gate, alarm system or similar is activated
(may take a few seconds). If the button is
depressed for more than 20 seconds then the
reprogramming is started. The indicator lamp illu-
minates or flashes when the button has been
depressed. Naturally the original remote controls
can still be used in parallel with HomeLink
®
if
required.
NOTE
If the ignition is switched off, HomeLink
®
will
work for 30 minutes after the driver's door
has been opened.
NOTE
HomeLink
®
cannot be used if the car is
locked and the alarm is armed from the out-
side.
22
Note that the toll-free number may not be available depending on operator.