||
DRIVER SUPPORT
350
If the driver enters a road
marked with a no-entry sign at
the roadside, the symbol for
this sign
89
flashes on and off
on the driver display as a warn-
ing.
If the car is equipped with Sensus Navigation
then information from the map is also used to
determine whether the car is being driven in the
wrong direction.
The driver can also get an acoustic warning when
driving towards a no-entry entrance if the
Road
Sign Audio Warning function is activated - see
the heading "Activating/deactivating the acoustic
warning" in the section "Activating/deactivating
Road Sign Information".
Speed limit or end of motorway
When RSI detects an "indirect speed limit sign"
stating the end of the current speed limit - e.g. at
the end of a motorway - a symbol appears with
the corresponding road sign in the driver's dis-
play.
Example of indirect speed limit sign
89
:
End of all restrictions.
End of motorway.
The driver display symbol extinguishes after
10-30 seconds and remains so until the next
speed related sign is passed.
Changed speed limit
When passing a direct speed limit sign when a
speed limit changes, a symbol with the corres-
ponding road sign appears in the driver's display.
Example of direct speed limit
sign
89
.
The driver display symbol extinguishes after
about 5 minutes and remains so until the next
speed related sign is passed.
Additional signs
Examples of additional signs
89
.
Sometimes different speed limits are signed for
the same road - an additional sign then indicates
the circumstances under which the different
speeds apply. The road section may be particu-
larly susceptible to accidents in rain and/or fog,
for example.
An additional sign relating to rain is displayed
only if the windscreen wipers are in use.
If a trailer is connected to the car's electrical sys-
tem and you pass a speed sign with the addi-
88
Road Sign Information
89
Road signs are market-dependent - the illustrations in these instructions only show examples.
To Next Page
