7
Important installation information
Please read this installation guide completely to ensure that all instructions are fully
understood before you install VanWeigh®
To ensure a reliable and properly functioning system particular importance should be paid to the
following:
• VanWeigh® axle transducer installation. A suitable location for the transducer should be
carefully identied and that location should then be prepared for the transducer to be attached.
See “How to install a steel axle transducer” on page 27
• VanWeigh® axle transducer orientation. Axle transducers must be mounted to the vehicle in
the correct orientation. See “How to install a steel axle transducer” on page 27
• Accurate recording of sensor serial numbers in their sensor positions. It is recommended that
you use the system conguration table to record this information and refer to it when you are
conguring the system. See “System conguration table” on page 68
VanWeigh
®
VanWeigh
®
To Next Page
Loading...