VTI Instruments EX1000A - Vtex10 Xxa_Set_Init

To Next Page

To Previous Page

VTI Instruments Corp.

242 EX10xxA/RX1032/EX1044 Function Calls

vtex10xxA_set_init_cont

FUNCTION PROTOTYPE

ViStatus vtex10xxA_set_init_cont(ViSession vi, ViBoolean init_cont_mode):

FUNCTION PARAMETERS

vi = contains a session handle to the instrument. This handle is obtained by the function and remains valid until the

session is closed.

init_cont_mode = a Boolean value indicating whether to enable init continuous mode. If this parameter is set to “1”,

init continuous mode is enabled. If set to “0”, init continuous mode is disabled.

DATA ITEM RESET VALUE

init_cont_mode = 0

DESCRIPTION

This function enables or disables the use of init continuous mode. Init continuous returns the trigger model to the

entrance of the ARM layer without the requirement of a new trigger initialize command.

EXAMPLE

VTI Instruments EX1000A - Vtex10 Xxa_Set_Init_Cont