www.vtiinstruments.com
EX10SC Signal Conditioning 287
FIGURE 9-5: COMPONENT LOCATIONS ON EX10SC PCB
Shunt Resistors
Optional shunt resistors can be installed by the user into sockets provided on the PCB. These
resistors allow for larger currents to be monitored when using the 8B32-02 or 8B42-01 modules.
The shunt resistor sockets are spaced on a 0.150” center. The sockets accept Vishay series S102
resistors, but similar resistors from other manufacturers can be used as well. Table 9-2 below shows
the relationship between the channel and its associated sockets.
To Next Page
Loading...
