www.vtiinstruments.com
EX10xxA Calibration 305
FIGURE 10-2: EX1044 CABLING DIAGRAM
NOTE If the Agilent 3458A is used, the “Auto Cal All” procedure should be performed prior to calibrating
the EX10xxA.
CONNECTING TO THE EX10XXA/RX10XX/EX1044
There are three ways to connect to the EX10xxA/RX10xx: using the IP address of the
EX10xxA/RX10xx, using Bonjour for auto-discovery, or using the Agilent Connection Expert
(ACE). For more information on obtaining the EX10xxA/RX10xx IP address and using this as the
connection method, refer to the Network Configuration discussion in Section 2. To connect to the
EX10xxA/RX10xx via Bonjour, refer to Section 4: Web Page Operation.
To use ACE, use the following steps:
1) Open ACE and click on the Add instrument toolbar.
2) Select Add LAN instrument on LAN and then click OK. ACE will search the network and
list the LXI instruments connected to the LAN.
FIGURE 10-2: ADD INSTRUMENT INTERFACE
3) To simply view the EX10xxA/RX10xx web page, click on its webpage button. If desired, the
EX10xxA/RX10xx can be added to ACE as a LAN instrument by enabling the appropriate
Select checkbox and then clicking OK.
To Next Page
Loading...
