VTI Instruments EX1000A - Default Settings

VTI Instruments Corp.
96 EX10xxA Programming
DEFAULT SETTINGS
The default instrument settings after an instrument reset or a power cycle are listed in Table 6-1.
Many programming applications do not require parameter changes from the default settings and can
be made far simpler by the elimination of redundant commands. The EX10xxA can be returned to
the reset state at any time by calling the vtex10xxA_reset function.
TRIGGER CONFIGURATION RESET VALUES
CONFIGURATION PARAMETER
RESET VALUE
Init Continuous
Disabled
Timer Interval (seconds)
0.1
Arm Source
Immediate
Arm Count
1
Arm Delay (seconds)
0
Trig Source
Timer
Trig Count
1
Trig Delay (seconds)
0
SCAN LIST CONFIGURATION RESET VALUES
CONFIGURATION PARAMETER
RESET VALUE
Scan List (enabled channels)
0
EU Conversions
mV (voltage)
Filter (hertz)
4.0
FIFO CONFIGURATION RESET VALUES
CONFIGURATION PARAMETER
RESET VALUE
CJC Temperature Reporting
Disabled
Timestamp Reporting
Disabled
Temperature Units
C
Blocking Mode
Disabled
DIGITAL I/O CONFIGURATION RESET VALUES
CONFIGURATION PARAMETER
RESET VALUE
Output State
0
Output Enable
Disabled
TRIGGER BUS CONFIGURATION RESET VALUES
CONFIGURATION PARAMETER
RESET VALUE
Output State
0
Output Enable
Disabled
LIMITS CONFIGURATION RESET VALUES
CONFIGURATION PARAMETER
RESET VALUE
Lower Limit of Limit Set 0
-0.066
Upper Limit of Limit Set 0
0.066
Limit Set 0, Manual
Disabled
Lower Limit of Limit Set 1
-1e+38
Upper Limit of Limit Set 1
1e+38
DIO Limit Events
Disabled
DIO Limit Events, Invert
Disabled
DIO Limit Events, Latch
Disabled
DEVICE CONFIGURATION RESET VALUES
CONFIGURATION PARAMETER
RESET VALUE
Current Self Cal Data
Cleared
Network Configuration
Unaffected
Time Configuration
Unaffected
Lock
Unaffected
TABLE 6-1: DEFAULT SETTINGS