VTI Instruments EX1000A - Rack Ear Installation Option

VTI Instruments Corp.
38 EX10xxA Preparation for Use
Rack Ear Installation Option
The rackmount installation option includes all the parts necessary to mount the EX10xxA to the
front of a standard test rack.
Required Tools
1) #2 Phillips screwdriver
Parts List
Item#
Qty
Description
VTI P/N
1
2
Rack Ear, EX10XXA
41-0482-009
2
10
Screw, 6-32 x 3/8", Flat Head Phillips, 82°, Stainless Steel
37-0173-037
Assembly Procedure
1) Place the chassis on a protected work surface with its input connectors facing front.
2) Using a #2 Phillips screwdriver, install the rack ears (P/N: 41-0482-009) on the front of the
EX10xxA using five (5) 6-32 x 3/8” flat head Phillips stainless steel screws (P/N: 37-0173-037)
for each rack ear. Note that the “Optional Mounting Locations” in Figure 2-2 allow the
EX10xxA to be installed in a rack either flush or recessed.
OPTIONAL MOUNTING LOCATIONS
1 1x Per Side
2 5x Per Side
FIGURE 2-2: RACK EAR INSTALLATION DIAGRAM