www.vtiinstruments.com
EX10xxA/RX10xx/EX1044 Preparation for Use 311
FIGURE 12-2: RX10XX CHANNEL SCREW TERMINAL PLATE VIEW
6) Unscrew the captive screws to inserts the thermocouple wires/ U - Lugs into it.
7) Fix the thermocouple 'U' Lugs into screw terminals. Each channel has S,+ & - signals screws (‘S’
for Shield, ‘+’ for Positive input, ‘-‘ for Negative input). Refer the below channel layout diagram of
screw terminals.
To Next Page
Loading...
