VTI Instruments EX1000A - Page 313

www.vtiinstruments.com
EX10xxA/RX10xx/EX1044 Preparation for Use 313
TABLE 12-1: 13 PIN CIRCULAR CONNECTOR SIGNAL ASSIGNMENTS IN RX10XX (P1)
NOTE: 22 AWG wire can be used for the P1 connector cable looming
ATTENTION - Important safety instructions for RX10xx input supply
THE FOLLOWING PIN CONNECTION TO BE CAREFULLY CONNECTED WITH EXTERNAL SUPPLY. ANY MISTAKE IN THE
CONNECTION MAY LEAD TO SYSTEM DAMAGE
Pin
Description
P1/R
+28V_IN
P1/P
28V_RET
P1/P
28V_RET
P1/N
+28V_IN
1) Connect P1 mating connector cable loom and other end +28V_IN and +28V_RET signals into
28V DC power supply. Power Supply should be capable of produce 2Amps
2) Power ON the supply.
3) Wait for 2min time to system boot.
4) Run the SFP application software and configure the channel as per requirement.
5) Wait for warm up time as mentioned in "WARMUP TIME" section
6) Start acquire the channel data
P1/B
DAC0_OUT1
Not to be Used (Future Purpose)
P1/K
DAC0_OUT2
Not to be Used (Future Purpose)
P1/C
DAC1_OUT1
Not to be Used (Future Purpose)
P1/J
DAC1_OUT2
Not to be Used (Future Purpose)
P1/M
AGND
Not to be Used (Future Purpose)
P1/D
DIO1
General Purpose Digital I/O
P1/H
DIO2
General Purpose Digital I/O
P1/E
DIO3
General Purpose Digital I/O
P1/G
DIO4
General Purpose Digital I/O
P1/F
DGND
GND for General Purpose DIO