www.vtiinstruments.com
EX10xxA/EX10xxA-51C/RX10xx Preparation for Use 49
FIGURE 2-9: COMPLETED EX10XXA MAINFRAME STATIC IP CONFIGURATION
Click the Submit button. Once this is done, it is no longer possible to communication
with the EX10xxA mainframe. This is normal and is addressed in the following steps.
Set a static IP address for the NIC card by doing the following:
a) Navigate to Start → Settings → Network Connections.
b) Right click on the NIC card that the EX10xxA mainframe is connected to and select
Properties.
c) Select Internet Protocol (TCP/IP) and click Properties.
FIGURE 2-10: TCI/IP SELECTION
To Next Page
Loading...
