www.vtiinstruments.com
EX10xxA/EX10xxA-51C/RX10xx Preparation for Use 55
TABLE 2-5: 13 PIN CIRCULAR CONNECTOR SIGNAL ASSIGNMENTS IN RX10XX (P1)
NOTE: 22 AWG wire can be used for the P1 connector cable looming
ATTENTION - Important safety instructions for RX10xx input supply
THE FOLLOWING PIN CONNECTION TO BE CAREFULLY CONNECTED WITH EXTERNAL SUPPLY. ANY MISTAKE IN THE
CONNECTION MAY LEAD TO SYSTEM DAMAGE
28V Return DC Power Input
28V Return DC Power Input
Not to be Used (Factory Calibration Purpose)
Not to be Used (Factory Calibration Purpose)
Not to be Used (Future Purpose)
Not to be Used (Future Purpose)
Not to be Used (Future Purpose)
Not to be Used (Future Purpose)
Not to be Used (Future Purpose)
General Purpose Digital I/O
General Purpose Digital I/O
General Purpose Digital I/O
General Purpose Digital I/O
GND for General Purpose DIO
To Next Page
Loading...
