Chapter 4: Description of functions (abbreviated)
34
Chapter 4: Description of functions (abbreviated)
If parameter PP.00 is set to a non-zero number, parameter protection is enabled. You must
enter the correct user password to enter the menu. To cancel the password protection
function, enter the password and set PP.00 to 0. Parameter menus that the user
customizes are not password protected. Group P and B are the basic parameters of
functions, group D is for monitoring functional parameters.
The meaning of the symbols in the function code table is as follows:
„☆“ The parameter can be changed when the inverter is stopped or running.
„★“ The parameter cannot be changed when the inverter is running.
„●“ The parameter is actually the measured value and cannot be changed.
„*“ This parameter is a factory parameter and can only be set by the manufacturer.
Group P0: Parameters of basic functions
1: G type (constant torque load)
2: P type (variable torque, e.g. fan,
compressor, pump, etc.)
0: Voltage / frequency control (V/F)
1: Non-feedback vector control (SFVC)
2: Vector feedback control (CLVC)
To Next Page
Loading...