VYBO Electric Vector V810 - Group P9: Faults and Protection

Chapter 4: Description of functions (abbreviated)
60
Group P9: Faults and protection
P9.00
Selection of overload
protection
0: OFF
1: Enabled (ON)
1
☆
P9.01
Increasing motor
overload protection
0.20 to 10.00
1.00
☆
P9.02
Motor overload warning
coefficient
50% to 100%
80%
☆
P9.03
Increasing overload of
DC overvoltage
0 to 100
0 = no overvoltage
(set 0 to when dynamic braking is activate)
10
☆
P9.04
Overvoltage stall
protective voltage
120% to 150%
130%
☆
P9.05
Overcurrent increasing
0 to 100
20
☆
P9.06
Overcurrent protection
100% to 200%
150%
☆
P9.07
To test short to ground
after switching on
0: Disabled
1: Enabled
1
☆
P9.09
Automatic recovery time
after fault
0 to 20
0
☆
P9.10
Output state YO during
auto-recovery after
malfunction
0: No activity
1: Activity
0
☆
P9.11
Auto-recovery interval
after malfunction
0.1s - 100.0s
1.0s
☆
P9.12
Turn on protection when
the input phase fails
0: Protection disabled (Off)
1: Protection allowed
1
☆
P9.13
Turn on protection when
the output phase fails
0: Protection disabled (Off)
1: Protection allowed
1
☆