Wacker Neuson Dumper 6001 - Procedure; Engine warm-up; Jump-starting the engine (supply battery)

BA 5001-6001 US – Edition 1.2 * 6001b330.fm 3-15
Operation
Procedure
After you have completed the starting preparations:
☞ Insert the starter key into the preheating/start switch 15.
☞ Turn the starter key to position “1”
☞ Check whether the following indicators come on:
➥ Indicator 8 for engine oil pressure.
➥ Indicator 6 for alternator charge function.
☞ Replace defective indicators immediately.
☞ Turn the starter key to position “2” and hold it in this position until the preheating
indicator goes out.
☞ Turn the starter key to position “3” and hold it in this position until the engine starts.
➥ If the engine does not start after 10 seconds.
☞ Interrupt the start procedure and try again after 1 minute.
➥ If the engine still does not start after the second try.
☞ Contact a Wacker Neuson service facility for troubleshooting.
➥ As soon as the engine runs:
☞ Release the starter key.
When the engine runs smoothly (increased engine speed):
Important
In general, a battery delivers less energy in cold conditions. Therefore make
sure the battery is always well charged.
1
0
2
3
Fig. 27: Preheating start switch
15
Fig. 28: indicators
8
3