28
GM 4700AC
OPERATING MANUAL
VERSION 06/2014 ORDER NUMBER DOC2311730
7.2.1 GENERAL RULES FOR MAKING ADJUSTMENTS TO THE SPRAY GUN
WARNING
Unintentional putting into operation!
Risk of injury
Before any work on the device, in the event of work interruptions
and malfunctions:
Switch o the energy/compressed air supply.
Relieve the pressure from the spray gun and unit.
Secure the spray gun against actuation.
In the event of functional faults, remedy the fault as described in
the "Troubleshooting and recti cation" chapter.
Observe safety instructions in Chapter 4.
WARNING
High-pressure spray jet!
Danger to life from injecting paint or solvent
Never reach into the spray jet.
Never point the spray gun at people.
Consult a doctor immediately in the event of skin injuries caused
by paint or solvent. Inform the doctor about the paint or solvent
used.
Never seal defective high-pressure parts; instead relieve the
pressure from them and replace them.
Wear the appropriate protective clothing, gloves, eyewear and
respiratory protection.
To Next Page
Loading...
