WAGO Pro 2 - Standards; Table 33 Standards: Mechanical and Climatic Environmental Conditions; Table 34 Standards: EMC - Immunity to Interference; Table 35 Standards: EMC - Emission of Interference

2787-2146 (/0000-00x0)Properties
26 Product manual | Version: 1.2.2
Power Supply Pro 2
Note
More information on approvals
You can find detailed information on the approvals online at:
üwww.wago.com/<item number>
3.10.3 Standards
The product meets the following standards:
Table33: Standards: Mechanical and Climatic Environmental Conditions
Standard Test Value
Mechanical Environmental Conditions
EN 60068-2-6 f = 5 …150Hz: 1g, 3.5 m
IEC 60068-2-27 shock 15g, 11ms, 3 shocks per axis and direction, half-sine
EN61131-2, sec. 4.3 Freefall ≤300 mm (packaged in the product packaging)
Climatic Environmental Conditions
EN 60870-2-2 3K3 (except for low air pressure)
Table34: Standards: EMC – Immunity to Interference
Standard Title
EN IEC 61204-3 Low-Voltage Switch Mode Power Supplies – Part 3: Electromagnetic Com-
patibility (EMC)
EN IEC 61000-6-2 Part 6-2: Generic standards – Immunity for industrial environments
EN 61000-4-2 Part 4-2: Testing and measurement techniques – Electrostatic discharge im-
munity test
EN 61000-4-3 Part 4-3: Testing and measurement techniques – Radiated, radio-frequency,
electromagnetic field immunity test
EN 61000-4-4 Part 4-4: Testing and measurement techniques – Electrical fast transient/
burst immunity test
EN 61000-4-5 Part 4-5: Testing and measurement techniques – Surge immunity test
EN 61000-4-6 Part 4-6: Testing and measurement techniques – Immunity to conducted dis-
turbances, induced by radio-frequency fields
EN 61000-4-8 Part 4-8: Testing and measurement techniques – Power frequency magnetic
field immunity test
EN 61000-4-11 Part 4-11: Testing and measurement techniques – Voltage dips, short inter-
ruptions and voltage variations immunity tests
Table35: Standards: EMC – Emission of Interference
Standard Title
EN IEC 61204-3 Low-Voltage Switch Mode Power Supplies – Part 3: Electromagnetic Com-
patibility (EMC)
EN 61000-6-3 Part 6-3: Generic standards – Emission standard for residential, commercial
and light-industrial environments
Table36: Standards: LVD – Low Voltage Directive
Standard Title
EN IEC 61010-2-201 Safety requirements for electrical equipment for measurement, control, and
laboratory use - Part2-201: Particular requirements for control equipment
EN 61010-1 Safety requirements for electrical equipment for measurement, control, and
laboratory use - Part 1: General requirements