WAGO Pro 2 - Page 51

2787-2146 (/0000-00x0) Configuration
Product manual | Version: 1.2.2 51
Power Supply Pro 2
Modbus
This section contains specific parameters for the Modbus RTU Communication Module.
The configured parameters are first transferred to the WAGO Power Supply Pro 2. As
soon as the Modbus RTU Communication Module is attached, the parameters are used
here accordingly.
More information about the Modbus RTU Communication Module is available in the re-
spective & Product Manual and in section 8Accessories – Communication [}72].
Figure30: Dialog: Settings – Modbus
Table59: Dialog: Settings – Modbus
Section Parameters Description
General Device Address The device address can be entered here.
Response delay The response delay (unit: ms) can be entered here.
Baudrate The baud rate can be selected here.
Parity The parity can be selected here.
Stop bits The number of stop bits can be selected here.
Data format The data format can be selected here: