Walter SURFOX 306 - Page 30

30
C
SURFOX 306 USER MANUAL
To prevent the electrolyte from entering
the device via the fume abatement
system, do not use the wand facing
upwards.
Only use DW wand for this type of work
(see chapter 7).
• The polishing process requires a greater
amount of electrolyte solution than pickling.
• Always keep the brush/pad well moistened
with the electrolyte solution to avoid
overheating and a consequent signicant
reduction in its working life; if there
are obvious signs of wear, replace the
component immediately.
• If the power and/or voltage is increased
during processing, the electrolyte solution
evaporates faster; compensate for the
evaporation of the liquid by increasing
the pump speed (in dynamic mode this is
not necessary; see chapter 3.5 for more
details).
• Never use an insert without its matching
pad; the insert must never be placed in
direct contact with the steel workpiece.
• When cleaning/polishing, keep the brush
perpendicular to the weld and never press
the carbon bristles excessively against the
surface to be treated (C).
• For best results, adjust the brush bristle
length as needed (see chapter 4.7)
NO!
NO!