C External Connections
74 July 7, 2014, 715003736IVD Rev. C
2. Using the flat-blade screwdriver, attach the positive and negative leads
of the signal cable to the connector.
3. Fit the grounding cable’s fork terminal on the rear panel grounding
stud, and secure the terminal with the locking nut.
Tip: Use the 9/32-inch nut driver to tighten the locking nut until the fork
terminal does not move.
Signal cable
Screw
Connector
Fork terminal
Locking nut
Grounding stud
To Next Page
Loading...
