Waters ACQUITY UPLC I-Class IVD - Sample Manager I;O Signal Connectors

Signal connections
July 7, 2014, 715003736IVD Rev. C 77
Sample manager I/O signal connectors
The rear panel of the sample manager includes a removable connector that
holds the screw terminals for I/O signal cables. This connector is keyed so that
it can receive a signal cable inserted only one way.
Requirement: A contact closure output connection (Inject Start Out) from the
sample manager is required to trigger a mass spectrometer.
Sample manager I/O signal connectors:
For electrical specifications, see Appendix B.
Chart-out signal conditions:
Signal
Parameter Setting at 0
Volts (Minimum)
Parameter Setting at
2.000 Volts (Maximum)
Flow Rate 0.000 mL/min 2 mL/min
System Pressure –345 kPa (–3.45 bar,
–50 psi)
124,106 kPa (1241 bar,
18,000 psi)
Composition 0.0% 100.0%
Inject Start Out + Inject Start Out - Ground Ground Inject Hold In + Inject Hold In -
12
3
456