Waters TQ Detector - Installing Low-Volume Vials

Preparing the IntelliStart fluidics system 2-9
Preparing the IntelliStart fluidics system
See also: Appendix B of the Waters TQ Detector Operator’s Guide.
Installing the solvent manifold drip tray
Required materials
Chemical-resistant, powder-free gloves
To install the solvent manifold drip tray:
Install the solvent manifold drip tray as shown below:
Warning: The solvent manifold drip tray can be contaminated
with biohazardous and/or toxic materials. Always wear
chemical-resistant, powder-free gloves while performing this
procedure.
TP02685