Waters TQ Detector - Leaving the Instrument Ready for Operation; Emergency Instrument Shutdown Procedure

To Next Page

To Previous Page

2-14 Preparing the Waters TQ Detector for Operation

Rebooting the TQ Detector

Sometimes you might need to reboot the TQ Detector:

• When the Tune window fails to respond.

• When MassLynx fails to initialize.

• Immediately following software download.

Rebooting the TQ Detector by pressing the reset button

Tip: The reset button shuts down the electronics momentarily and causes the

TQ Detector to reboot.

To reboot the TQ Detector by pressing the reset button:

1. Open the TQ Detector’s front left door.

2. Press the red reset button on the top, left-hand side of the instrument.

TP02687

Reset button

Other manuals for Waters TQ Detector