Watlow F4P Series

Watlow Series F4P Parameters ■ 6.3
✔ Note: For more information about how parameter settings affect the
controller’s operation, see the Features Chapter.
Main Page Parameter Table Modbus
Register
Range read/write Conditions for
Parameter Description (Modbus Value) Default (I/O, Set) Parameters to Appear
Go to Factory
Set security settings, cal-
ibrate and restore factory
settings, perform diag-
nostics, test outputs.
Go to Setup
Set up inputs and out-
puts, configure the sys-
tem, design the Main
Page, configure alarms,
configure communication,
and define static mes-
sages.
Go to Operations
Auto-tune PID sets, edit
PID parameters, select
alarm set points, select
PID crossover, select
ramp to set point, select
control set points, and
mode.