Watlow F4P Series

1 PID Set 1
2 PID Set 2
3 PID Set 3
4 PID Set 4
5 PID Set 5
307 Autotune PID Type, Autotune PID
r/w 0 Heat Only,
1 Cool Only
2 Heat and Cool
304 Autotune Set Point, System
r/w 50 to 150%
884 Boost Delay Time, Control Set Points
r/w 0 to 999 seconds
881 Boost Power Mode, Control Output 1B
r/w 0 Auto Only
1 Auto/Manual
883 Boost Power, Control Set Points
r/w 0 to 1000% (in tenths)
309 Boost Set Point (1B), Control Set Points
r/w -19999 to 30000 [deviation]
Set Point Low Limit to Set Point High Limit [process]
882 Boost Set Point Type, Control Output 1B
r/w 0 Process
1 Deviation
885 Boost Type, Control Output 1B
r/w 0 Boost on Power
1 Boost on Set Point
1603 Calibrate Input 1, Calibration
r/w 1 0.00mV Thermocouple
2 50.00mV Thermocouple
3 32°F Type J
4Ground
5 Lead
6 15.0 ohms RTD
7 380.0 ohms RTD
8 0.000V
9 10.000V
10 4.000mA
11 20.000mA
1608 Calibrate Input 2, Calibration
r/w 1 0.00mV Thermocouple
2 50.00mV Thermocouple
3 32°F Type J
4Ground
5 Lead
6 15.0 ohms RTD
7 380.0 ohms RTD
8 0.000V
9 10.000V
10 4.000mA
11 20.000mA
1613 Calibrate Input 3, Calibration
r/w 1 0.00mV Thermocouple
2 50.00mV Thermocouple
3 32°F Type J
4Ground
5 Lead
6 15.0 ohms RTD
7 380.0 ohms RTD
8 0.000V
9 10.000V
10 4.000mA
11 20.000mA
12 15.0 ohms Slidewire (F4P_-_ _ AB-_ _ _ _ models only)
13 1000.0 ohms Slidewire (F4P_-_ _ AB-_ _ _ _ models only)
1606 Calibrate Process Output 1A, 1.000V
r/w 0 to 3000V (in thousandths)
1607 Calibrate Process Output 1A, 10.000V
r/w 0 to 12000V (in thousandths)
1605 Calibrate Process Output 1A, 20.000mA
r/w 0 to 24000mA (in thousandths)
1604 Calibrate Process Output 1A, 4.000mA
r/w 0 to 6000mA (in thousandths)
1611 Calibrate Process Output 1B, 1.000V
r/w 0 to 3000V (in thousandths)
1612 Calibrate Process Output 1B, 10.000V
r/w 0 to 12000V (in thousandths)
1610 Calibrate Process Output 1B, 20.000mA
r/w 0 to 24000mA (in thousandths)
1609 Calibrate Process Output 1B, 4.000mA
r/w 0 to 6000mA (in thousandths)
1626 Calibrate Retransmit Output 1, 1.000V
r/w 0 to 3000V (in thousandths)
1627 Calibrate Retransmit Output 1, 10.000V
r/w 0 to 12000V (in thousandths)
1625 Calibrate Retransmit Output 1, 20.000mA
r/w 0 to 24000mA (in thousandths)
1624 Calibrate Retransmit Output 1, 4.000mA
r/w 0 to 6000mA (in thousandths)
1631 Calibrate Retransmit Output 2, 1.000V
r/w 0 to 3000V (in thousandths)
1632 Calibrate Retransmit Output 2, 10.000V
r/w 0 to 12000V (in thousandths)
1630 Calibrate Retransmit Output 2, 20.000mA
r/w 0 to 24000mA (in thousandths)
1629 Calibrate Retransmit Output 2, 4.000mA
r/w 0 to 6000mA (in thousandths)
605 Calibration Offset Value, Analog Input 1
r/w Set Point Low Limit to Set Point High Limit
615 Calibration Offset Value, Analog Input 2
r/w Set Point Low Limit to Set Point High Limit
625 Calibration Offset Value, Analog Input 3
r/w Set Point Low Limit to Set Point High Limit
1927 Cascade High Deviation, Analog Input 3
r/w 1 to 9999
1927 Cascade High Range, Analog Input 3
r/w <sensor range>
305 Cascade Inner Loop, Autotune PID Set
r/w 0 Tune Off
1 PID Set 1
2 PID Set 2
3 PID Set 3
4 PID Set 4
5 PID Set 5
1922 Cascade Internal Set Point
r
1926 Cascade Low Deviation, Analog Input 3
r/w -19999 to -1
1926 Cascade Low Range, Analog Input 3
r/w <sensor range>
1925 Cascade, Analog Input 3
r/w 0 Process Cascade
1 Deviation Cascade
343 Cascade Outer Loop, Autotune PID Set
r/w 0 Tune Off
1 PID Set 1
2 PID Set 2
3 PID Set 3
4 PID Set 4
5 PID Set 5
1501 CJC1 AtoD, Diagnostic
r HHHH see In 1 AD
1500 CJC1 Temp, Diagnostic
r xx.x
1532 CJC2-CJC3 AtoD, Diagnostic
r HHHH see In 1 AD
1531 CJC2-CJC3 Temp, Diagnostic
r xx.x
312 Clear Alarm 1, Key Press Simulation
w write any value
331 Clear Alarm 2, Key Press Simulation
w write any value
311 Clear Error Input 1, Key Press Simulation
Watlow Series F4P Communications ■ 9.3
✔ NOTE:
For more infor-
mation about
parameters, see
the Index.