Watlow PM LEGACY PM3 - Chapter 4: Home Page

Watlow PM LEGACY™ Limit Controller • 36 • Chapter 4 Home Page
Chapter 4: Home Page
4
Default Home Page Parameters
Watlow's patented user-defined menu system improves operational efficiency. The user-defined
Home Page provides you with a shortcut to monitor or change the parameter values that you use
most often. The default Home Page is shown on the following page. When a parameter normally lo-
cated in the Setup Page or Operations Page is placed in the Home Page, it is accessible through
both. If you change a parameter in the Home Page, it is automatically changed in its original page. If
you change a parameter in its original page it is automatically changed in the Home Page.
Use the Advance Key to step through the other parameters. When not in pairs, the parameter prompt
will appear in the green display, and the parameter value will appear in the upper display. You can
use the Up or Down keys to change the value of writable parameters, just as you would in any
other menu.
Note:
If a writable value is placed on the red display and is paired with another read only parameter on
the green display, the arrow keys affect the setting of the red display. If two writable parameters are
paired, the arrow keys affect the green display.
• The Attention attn parameter appears only if there is an active message. An example of an ac-
tive message could be a Input Error Er.i1.
• If a sensor failure has occurred, dashes
----
will be displayed in the red display.