Installation and Connection
3
CFW-11 | 3-13
Frame Sizes F, G and H:
In order to get access to the control terminals, it is necessary to remove the HMI and the control rack cover, as
showed in Figure 3.12 on page 3-13.
1 2 3
Figure 3.12 - Removal of the HMI and the control rack cover - frame sizes F, G and H
In order to get access to the power terminals, it is necessary to remove the bottom front cover, as shown in
Figure 3.13 on page 3-13.
1 2
Figure 3.13 - Removal of the bottom front cover, to access to the power supply and motor connection terminals -
frame sizes F, G and H
In order to connect the power cables (line and motor), remove the bottom plate, as shown in Figure 3.14 on
page 3-13. In this case the protection degree of the inverter bottom part will be reduced.
Figure 3.14 - Removal of the bottom plate, to access the power terminals - frame sizes F, G and H
To Next Page
Loading...
