page 8 – 8
D-5000 / May 2000
CPU & DSP MODULES
SW4 position 41- not used
SW4 position 42 - 8dB
SW4 position 43 - 4dB
SW4 position 44 - 2 dB
Note: These switches set the fader scale factor that will be applied to
each input module at the DSP stage. Default setting is 12dB (DSW42 and
DSW43 “ON”).
SW6 - RS-485/RS-232 Select
Four position dipswitch SW6 located on the upper right side of the card
selects the hardware interface type (RS-485 or RS-232) for each serial Com
port.
OFF ON Serial Port
SW6 position 1 RS-485 RS-232 Com Ø
SW6 position 2 RS-485 RS-232 Com 1
SW6 position 3 not used
SW6 position 4 not used
SW7 - RS-485 Termination
Four position dipswitch SW7 located right next to the card’s short upper
row of gold fingers are used for RS-485 termination. Termination must be
switched in pairs (i.e., TX and RX BOTH ON or BOTH OFF) for a given
Com X port.
OFF ON Serial Port
SW7 position 1 Not terminated Terminated Com Ø - TX
SW7 position 2 Not terminated Terminated Com Ø - RX
SW7 position 3 Not terminated Terminated Com 1 - TX
SW7 position 4 Not terminated Terminated Com 1 - RX
CPU-600 Reset Switch
Push-button switch SW5 with green cap (lower right side of card) will
reset the CPU-600 hardware and initiate a re-boot of the CPU-600 firm-
ware. This sequence is sometimes called a “soft boot”, because the
console’s power supply is not cycled OFF/ON.
Global
Gain
To Next Page
Loading...