page 9 – 12
D-5000 / July 2000
V I R T U A L D I P S W I T C H
Ending the Program
Once the console text and settings are to your liking, and have been
written to the console, and saved to a file if desired, the VDip program
can be ended by selecting “Exit” from the “File” menu. The console
settings will remain as you have set them until the next time the VDip
program is run. You can remove the computer connection or leave it
hooked up, as you desire. Note that if you leave the connection to the
computer in place, you should set the large switch on the CPU-600
module to “local” in case some other program on the computer tries to
write to the COM port. It is unlikely that a stray message sent out the
COM port will cause any changes because it will be ignored unless it
is sent in the precise D-5000 serial protocol, but simply switching the
console to “local” provides extra insurance.
To Next Page
Loading...