page 2 – 10
IP-12/IP-16 / Dec 2014
SURFACE CONFIGURATION
OL Pre On – When checked, causes the signal, when assigned to the surface’s
OL output, to be tapped before the channel ON switch.
Mach Start Pulsed – If this box is not checked, a Machine Start command will
give a steady closure, similar to an On Tally. If your external machine needs to see a
momentary pulse instead, check this box.
Remote Ready – The channel’s OFF switch normally has its LED indicator controlled
by the switch itself. This is the factory default setting. When Remote Ready is checked,
the channel’s OFF switch LED can be controlled by an external source machine. This
requires additional conguration in the optional Navigator GUI to fully implement
the feature.
OL Off Line – This function determines what will be heard at the fader’s Bus Minus
output when the fader is off. If the box is not checked, when the fader is off the same
bus will feed the bus minus that feeds it when the fader is on, as determined by the
Bus Minus Base Mix selection below. But if the OL Off Line box is checked, when
the fader is off the Bus Minus output will be fed from the OL bus instead.
Studio Mutes – Input channels can be programmed to mute the various monitors when
the channel is ON. There are four Studio Mutes checkboxes, one for each monitor
section plus one for CUE. The checked boxes show which monitors are muted.
Studio Tallies – Turning the channel ON can activate a remote tally indicator. There
are four tally control lines. The checked boxes show which tallies are activated. This
requires additional conguration in the optional Navigator GUI to fully implement
the feature.
Bus Minus Direct Out – For each fader, determines if the Bus Minus output is a
mix-minus of the selected Bus Minus Source (unchecked) or is a Direct Output of
the selected input source (checked). On faders where the Bus Minus Direct Out box
is checked, the OL Off Line box (above) will have no effect.
Bus Minus Base Mix – This function determines which bus the Bus Minus output is
a mix-minus of. Any of the four PGM, AUD, AUX, or OL busses can be selected as
the Bus Minus Source. If, for example, PGM is selected, then the Bus Minus output
will consist of the audio on the PGM Bus, minus the signal assigned to the fader. This
is true when the fader is turned on. It also true when the fader is turned off, unless
the OL Off Line box is checked (above). This setting will have no effect on any fader
where the Bus Minus Direct Out box is checked (above).
To Next Page
Loading...