6-12
Step Display
Indication
Explanation
1 1h.XX Help Code 1, where XX is the help
code number.*
2 2h.XX Help Code 2, where XX is the help
code number.*
3 3h.XX Help Code 3, where XX is the help
code number.*
4 1.X## Error history code 1, where X is
the F or d code, and ## is the
code number.**
5 2.X## Error history code 2, where X is
the F or d code, and ## is the
code number.**
6 3.X## Error history code 3, where X is
the F or d code, and ## is the
code number.**
7 4.X## Error history code 4, where X is
the F or d code, and ## is the
code number.**
8 SC.XX CCU software revision, where XX
is the software revision number.
9 EC.XX CCU EEPROM revision, where XX
is the EEPROM revision number.
10 SU.XX UI software revision , where XX is
the software number.
11 EU.XX UI EEPROM revision, where XX is
the EEPROM number.
12
SPIN
.XXX
The current speed of the spin
basket, displayed in rpm.
13 P.XXX The relative amount of power
requested by the motor, where
XXX is the value.
14 U.XXX The unbalance in the system,
where XXX is the unbalance
value.***
HELP MODE SUBMENU
HELP CODES
* To erase the 3 help codes, press COLD Button.
** The Errors displayed in this section are the history errors that have
occurred in the washer (not necessarily an error that is in progress).
The current error is displayed in the MANUAL KEY FUNCTION IN
DIAGNOSTIC SUB-MODE.
*** The values 255 and 254 are reserved numbers for specic cases.
(255=unbalance has not been calculated yet, 254=unbalance could
not be calculated.)
Help
Code
Description
0F Oversuds detected during cycle, and washer
was not able to resolve an unbalance
condition detected during the nal spin related
to the oversuds detection (via pressure
sensor) earlier in the cycle.
NOTE: SudS and 0 minutes alternating on
display while door is unlocked happens when
excess suds is detected in the nal spin and
washer could not reach spin speeds. This
display continues after cycle is aborted. SudS
is displayed on screen for 2 minutes or until
the door is closed, whichever happens sooner.
32 More than 6 unbalance retries during the nal
spin – spin (and cycle) has been aborted
33 Oversuds detected during wash cycle, and
washer was not able to resolve the condition
– cycle has been aborted. Washer unable
to sense that water has been fully drained
within required time, sensing as an oversuds
condition.
NOTE: SudS and 0 minutes alternating on
display with door locked happens when cycle
is aborted after the second drain, because
washer is unable to get rid of excess suds.
Door will remain locked for approx. 3 min.
(shortened in video) then door unlocks, this
continues until the door is opened. SudS is
displayed on screen for 2 minutes or until the
door is closed, whichever happens sooner.
71 Generation 2 debit card cycle polling message
out of sequence
74 Generation 2 debit card remaining balance
message out of sequence
75 Generation 2 debit card new card balance
message out of sequence
88 Invalid messaging state found in da
communications comm_suprv ( ) routine
To Next Page
Loading...
