Whirlpool CHW9050 - CCU Wire Harness Connector Table

6-14
CCU WIRE HARNESS
CONNECTOR TABLE
Unplug washer or disconnect power
before taking ohm measurements
6-14
CCU WIRE HARNESS
CONNECTOR TABLE
Unplug washer or disconnect power
before taking ohm measurements
*
The number 1 pin has been marked
on the locking part of the connector.
**An innity measurement occurs when the
multimeter does not detect an ohm reading,
1, 2
Control Transformer
�Ω
(Ω)
1
1
1
1
CCU Wire Harness Connector Table
Unplug washer or disconnect power before taking ohm measurements.
HE2 Wax Motor 1.2kΩ
at 25°C
DLS2 Door Locked Switch Continuity: 1, 2
Locked/Unlocked door locked.
No Continuity:
door unlocked.
DL3 Door Lock Coil 165Ω Infinity**
1, 2 door lock
Locked or Unlocked 2, 3 door unlock
T
Sensor temperature
changes.
See above.
DP2 Drain Pump 13Ω
D
1, 2
at door close.
No continuity
at door open.
DI6 Cold Inlet Valve #2 812Ω
valve #1)
VCH7 Cold Inlet Valve #3 812Ω
(or more than valve #2)
10% lower 5, 7 (hot
IF2
1
30
RFI &
Infinity**
(or more than
10% lower
or higher)
1, 2
Pressure Switch
�Ω
PR6
30
Infinity**
for all except
1
3, 4
4, 5
4,6
4,6
with no
water
in tub
Infinity** 1, 2
1, 2
Infinity** 1, 2
Infinity** 1, 3 (cold
1, 3 (cold
or higher) valve #3)
H2 Temperature Varies with Infinity**
, Infinity**
Hot Inlet Valve #1 eith r coil
e
S2 Door Switch
Continuity
which indicates an open switch or circuit.
Coding
Ohm Abnormal Pin Wire
Terminal Component Value Value Connectors*