Whirlpool CHW9050 - How to Use the Buttons to Program Controls; Start Operating Set-Up

3-6
Before proceeding, it is worth noting that,
despite all of the options available, an
owner can simply choose to uncrate a new
commercial washer, hook it up, plug it in, and
have a washer that operates. Washers are
preset at the factory for an 11-minute wash
period and 3 rinses (no extra rinse).
SET-UP CODES
n The WARM button will advance from code
to code.
n The HOT button will change the code value.
n The COLD button will select or deselect
options.
The set-up code is indicated by the one or two
left-hand characters. The set-up code value
is indicated by the two or three right-hand
characters.
NOTE: The rst line of each code indicates
the factory default for 9050 models.
START OPERATING SET-UPHOW TO USE THE BUTTONS
TO PROGRAM CONTROLS
1. The HOT button is used to adjust the values
associated with set-up codes. Pressing the
button will change the value by increments.
Rapid adjustment is possible by holding
down the button.
2. The WARM button will advance through
the set-up codes. Pressing the button will
advance to the next available set-up code.
Holding the button down will automatically
advance through the set-up codes at a rate
of 1 per second.
3. The COLD button is used to select or
deselect options.