41
4. For the Service Technician
Press for
5 seconds
Language selection Deutsch
Boiler No
MB No
SMS No
ELG No
Ethernet
Choose Back
Boiler temperature
(Operating phases)
Info Menu
42
°C
Version V3.00
25.9.2013
4.7.5 Installation of MESplus modules
Display if an MESplus module is installed (connected) or uninstalled
(disconnected)
Installation procedure active
(Animated symbol)
4.8 InfoWINplus basic settings
Information!
Only trained service personnel may perform modifications in the basic settings.
The display switches to the basic settings when „Ver-
sion ....“ (Fig. 93) is displayed and the button (shown in
Fig.93) is pressed for 5 seconds.
„Version ...“ is displayed,
– if the „R“ button is pressed for 5 seconds on a stan-
dard display – Fig. 92;
– if the InfoWINplus was de-energised and then swit-
ched on.
The following settings are available in the basic set-
tings:
– Language selection
– Boiler
– MB
– SMS
– ELG
– Ethernet
– Update Software
– Update Firmware
The basic settings are used to
– set whether the InfoWINplus controls a wood or pellet boiler or whether it is solely used as master operation;
– switch the master operation functions on and off;
– activate/deactivate remote switching by text message.
The basic settings are undertaken in the factory before delivery as per the order.
Fig. 91
Fig. 92
Fig. 93
Fig. 94
To Next Page
Loading...
