Rugged Windows Tablet M101B/ M101BL User Guide
The GPS application cannot find my
location.
Make sure that GPS is powered on in Hottab.
Make sure that GPS receiver and the location
sensor are enabled in Control Panel.
The tablet computer may be out of coverage
area. Move your tablet computer outdoors or
closer to a window.
Check if your surroundings have interferences,
such as microwave ovens, cordless phones.
Move the tablet computer away from objects
causing interference.
Adjust volume of the tablet computer by
pressing on the volume rocker.
If using an external audio device, make sure
that the cable is properly connected.
I cannot project the tablet computer
display to another monitor.
Make sure the VGA driver is installed.
Make sure the output setting selected is
correct.
Barcode scanner does not emit laser
beam and does not seem to work.
Make sure the Barcode scanner device is
enabled in Hottab utility.
Make sure under Windows, the Barcode
Reader is set to COM 15 port, so that Hottab
can trigger the Barcode Reader hardware.
Barcode Scanner emits laser beam
but does not read barcode presented
to it.
Adjust the distance between barcode scanner
of the device and the barcode being scanned.
Make sure the barcode code type is enabled in
the tablet. To enable/disable a specific barcode
code type, go through the “Barcode Scanner
Configuration” section.
I am having GPS accuracy issue
When utilizing the GPS function, we
recommend disabling the Barcode Reader in
Hottab to reduce interference.
RFID scanner does not seem to work.
Make sure under Windows, the RFID hardware
is set to COM 3 port.
Battery leaking or swollen
The lithium battery used in this tablet may swell
after being charged/ discharged many times,
but there is no problem regarding safety.
Continued use in such a state may result in the
battery getting jammed, so please stop using
the battery, and purchase a new one.
To Next Page
Loading...
