Sawmill Alignment
Adjusting Bed Rails To The Blade
5
5-14 HDSdoc041620 Sawmill Alignment
5.7 Adjusting Bed Rails To The Blade
1. Move the clamp to its lowest position.
2. Move the saw head so the blade is positioned over the first bed rail.
3. Measure the distance between the bottom of the blade and the bed rail at each end of the bed rail.
Both distances should be equal.
See Figure 5-16.
4. Loosen the bed rail clamping bolts and turn the adjustment bolts to move the bed rails to the blade
if necessary.
5. Re-tighten the clamping bolts and adjustment bolts.
6. Without changing the saw head height, check all bed rails. Adjust them so that all measure the same
distance from the blade at both ends of the bed rail.
FIG. 5-16
Blade
Clamp bolt
Adjustment bolts
A
B
A=B
To Next Page
Loading...
