Wood-mizer LX450 Series - Operational Specifications (Cutting Capacity, Noise, Dust Extraction)

Safety & General Information
Cutting Capacity
Safety & General Information doc041620 1-15
1
1.9 Cutting Capacity
See Table 1-4. The log size capacities of the LX450 sawmill are listed below.
See Table 1-5. See the table below for the possible forward feed rates on the LX450 sawmill.
1.10 Motor Specifications
See Table 1-6. See the table below for technical data on the motors used on the LX450E25 sawmill.
See Table 1-7. See the table below for power supply specifications for the LX450E25 sawmill.
DANGER! It is recommended that a 30mA GFI (Ground Fault
Interrupter) be used.
Maximum Log
Diameter
Maximum
Length
LX450 92 cm 6.2 m
TABLE 1-4
Sawmill Model Cutting Rate
LX450 0-30 m/min.
TABLE 1-5
Motor Type Manufacturer Model No. Other Data
Electric Motor E25,
18.5 kW
Siemens, Germany 1LA7166-2AA60Z 3 x 400V, 50 Hz, 33.8A
2930 r.p.m.
Up/Down Motor 0.55kW Besel SKh71X-4C2/HPS08 3x230/400VAC, 50Hz
Power Feed Motor
1.1kW
Besel SKh90-4S2 HPS 230/400V, 50 Hz
1380 r.p.m.
TABLE 1-6
3 Phases
V
Fused
Disconnect
Switch
Recommended
Wire Size
400 VAC 63 A
16 mm
2
maximum length: 15 m
TABLE 1-7