Sawmill Alignment
Blade Guide Arm Adjustment
Sawmill Alignment HDSdoc041620 5-15
5
5.8 Blade Guide Arm Adjustment
The blade guide arm moves the outer blade guide in and out. If the arm becomes loose, the blade
guide will not deflect the blade properly, causing inaccurate cuts. A loose blade guide arm can also
cause blade vibration.
1. Adjust the blade guide arm in to 15 mm (1/2") from fully closed.
2. Manually try to move the arm up and down. If you can move the arm by hand, you will need to tighten
the arm rollers.
See Figure 5-17. Loosen the locking nuts. Next loosen the jam nuts and turn the adjustment bolts in
to tighten the blade guide arm rollers. Re-tighten the jam and locking nuts.
FIG. 5-17
Roller Adjustment
Bolts with Jam Nuts
Locking Nuts
To Next Page
Loading...
