Sawmill Alignment
Pre-Alignment Procedures
Sawmill Alignment HDSdoc041620 5-1
5
SECTION 5 SAWMILL ALIGNMENT
5.1 Pre-Alignment Procedures
The Wood-Mizer sawmill is factory aligned. Two alignment procedures are available to realign the
sawmill if necessary. The Routine Alignment instructions should be performed as necessary to solve
sawing problems not related to blade performance. The Complete Alignment procedure should be
performed approximately every 1500 hours of operation (sooner if you regularly transport the sawmill
over rough terrain).
Routine Alignment Procedure:
1. Install and track the blade (See Section 5.3
).
2. Check the angle of the blade in relation to the bed rails and adjust the lower track rollers if necessary
(See Section 5.18
).
3. Check and adjust the vertical alignment of the blade guide arm (See Section 5.8
).
4. Check and adjust the horizontal alignment of the blade guide arm (See Section 5.9
).
5. Check and adjust the vertical angle of the blade guides (See Section 5.11
).
6. Check and adjust the horizontal angle of the blade guides (See Section 5.13
).
7. Check and adjust the spacing between the blade guide flanges and the back of the blade (See
Section 5.12).
8. Check and adjust the horizontal angle of the side supports (See Section 5.15
).
9. Check and adjust the vertical angle of the side supports (See Section 5.16
).
10. Check that the blade height scale accurately displays the actual distance from the bottom of the
blade to the bed rails and adjust if necessary (See Section 5.18
).
Complete Alignment Procedure:
Perform all steps in this section to completely realign the sawmill.
To Next Page
Loading...
