Safety & General Information
Use Proper Maintenance Procedures
1
1-8 doc041620 Safety & General Information
WARNING! Use extreme caution when spinning the blade wheels by
hand. Make sure your hands are clear of the blade and wheel spokes
before spinning. Failure to do so may result in serious injury.
Use Proper Maintenance Procedures
DANGER! Make sure all electrical installation, service and/or
maintenance work is performed by a qualified electrician and is in
accordance with applicable electrical codes.
DANGER! Hazardous voltage inside the electric boxes and at the
motor can cause shock, burns, or death. Disconnect and lock out
power supply before servicing! Keep all electrical component covers
closed and securely fastened during sawmill operation.
WARNING! Consider all electrical circuits energized and dangerous.
WARNING! Disconnect and lock out power supply before servicing the
sawmill! Failure to do so may result in serious injury.
WARNING! Never assume or take the word of another person that the
power is off; check it out and lock it out.
WARNING! Do not wear rings, watches, or other jewelry while working
around an open electrical circuit.
WARNING! Remove the blade before performing any service to the
motor or sawmill. Failure to do so may result in serious injury.
DANGER! Never clean the blade or blade wheels with a brush
or a scraper during sawmill operation.
CAUTION! Before installation of the blade, inspect it for damage and
cracks. Use only properly sharpened blades. Always handle the blade
with extreme caution. Use suitable carrier equipment for transporting
the blades.
To Next Page
Loading...
