Setup & Operation
Replacing the Blade
Setup & Operation 15doc041620 2-9
2
See Figure 2-7.
Mount the cable hanger to the mast using fasteners showed in the LX450 Parts List (#804)
See Section 11.4
.
2.3 Replacing the Blade
DANGER! Always disengage the blade and shut off the sawmill
motor before changing the blade. Disconnect the power supply using
the main switch. Failure to do so will result in serious injury.
WARNING! Always wear gloves and eye protection when handling
bandsaw blades. Keep all other persons away from area when
FIG. 2-8
To Next Page
Loading...
