Wood-mizer LX450 Series - Adjustment of Side Supports

Sawmill Alignment
Adjustment of Side Supports
Sawmill Alignment HDSdoc041620 5-29
5
5.16 Adjustment of Side Supports
1. Place a flat board across the bed rails.
2. Move a side support up so that it is vertical.
3. Pull back at the top of the support to eliminate slack as if a log were being clamped against it.
See Figure 5-31.
4. Check the angle of each support with a square on the board.
5. The side support should be 90° to the bed rails. Using the adjustment nuts, adjust the side
support.
6. Repeat for the remaining side supports.
7. Raise the side support and check if they are on the same level.
FIG. 5-31
Side
Support
Square
Board
Adjustment
Nut