Wood-mizer LX450 Series - Table of Contents

4 SW-07doc041620 Table of Contents
Table of Contents Section-Page
General Contact Information
Branches & Authorized Sales CentersWood-Mizer Locations (North and South America)
SECTION 1 SAFETY & GENERAL INFORMATION 1-1
1.1 Safety Symbols.......................................................................................1-1
1.2 Blade Handling.......................................................................................1-2
1.3 Sawmill Setup.........................................................................................1-2
1.4 Sawmill Operation..................................................................................1-2
1.5 Sawmill Maintenance .............................................................................1-4
1.6 Safety Instructions..................................................................................1-5
Observe Safety Instructions
Wear Safety Clothing
Keep Sawmill and Area Around Sawmill Clean
Dispose Of Sawing By-Products Properly
Check Sawmill Before Operation
Keep Persons Away
Keep Hands Away
Use Proper Maintenance Procedures
Keep Safety Labels In Good Condition
1.7 Belt Sizes ..............................................................................................1-14
1.8 Blade Sizes ...........................................................................................1-14
1.9 Cutting Capacity...................................................................................1-15
1.10 Motor Specifications ............................................................................1-15
1.11 Noise Level...........................................................................................1-16
1.12 Sawdust Extractor Specifications.........................................................1-16
1.13 Overall Dimensions ..............................................................................1-17
1.14 Sawmill Components............................................................................1-20
SECTION 2 SETUP & OPERATION 2-1
2.2 Sawmills with cable guide......................................................................2-2
2.3 Replacing the Blade................................................................................2-9
2.4 Tensioning the Blade............................................................................2-10
2.5 Tracking the Blade ...............................................................................2-11
2.6 Starting the Motor.................................................................................2-14
2.7 Hydraulic Control Operation................................................................2-15
2.8 Loading, Turning and Clamping Logs .................................................2-17
2.9 Up/Down Operation .............................................................................2-19
2.10 Blade Guide Arm Operation.................................................................2-19
2.11 Power Feed Operation ..........................................................................2-20
2.12 Cutting the Log.....................................................................................2-22
2.13 Edging...................................................................................................2-23
2.14 Blade Drive Operation..........................................................................2-23
2.15 Power Feed Operation ..........................................................................2-25