Wood-mizer LX450 Series - Blade Guide Disc Adjustment

Sawmill Alignment
Blade Guide Disc Adjustment
5
5-26 HDSdoc041620 Sawmill Alignment
5.14 Blade Guide Disc Adjustment
To ensure correct cutting, adjust the gap between the blade guide disc and the blade. Perform the
adjustment with the blade installed and properly tensioned.
See Figure 5-27. Loosen both nuts and retaining bolts. Use the adjustment bolt to raise or lower the
disc until its distance from the blade is 0.3 - 0.5 mm. Then retighten the retaining bolts so that the
disc is parallel to the blade. Retighten the retaining bolt nuts.
See Figure 5-28. The gap between the disc and the blade should measure 0.3 - 0.5 mm.
FIG. 5-27
FIG. 5-28
Sm0205pl_b
Adjustment bolt
Loosen both nuts and
retainingbolts.
Adjustment bolt
Loosen both nuts
and retaining bolts
0.3-0.5 mm
Sm0290b