Wood-mizer LX450 Series - SECTION 1 SAFETY & GENERAL INFORMATION; Safety Symbols

Safety & General Information
Safety Symbols
Safety & General Information doc041620 1-1
1
SECTION 1 SAFETY & GENERAL INFORMATION
1.1 Safety Symbols
These symbols call your attention to instructions concerning your personal safety. Be sure to observe
and follow these instructions.
DANGER indicates an imminently hazardous situation which, if not
avoided, will result in death or serious injury.
WARNING suggests a potentially hazardous situation which, if not
avoided, could result in death or serious injury.
CAUTION refers to potentially hazardous situations which, if not
avoided, may result in minor or moderate injury to persons or
equipment.
Warning stripes are placed on areas where a single decal would be
insufficient. To avoid serious injury, keep out of the path of any
equipment marked with warning stripes.
Also read any additional manufacturer’s manuals and observe any applicable safety instructions
including dangers, warnings, and cautions.
Always be sure that all safety decals are clean and readable. Replace all damaged safety decals to
prevent personal injury or damage to the equipment. Contact Wood-Mizer Customer Service or the
Wood-Mizer distributor in your area to order a new decal.
IMPORTANT! It is always owner's responsibility to comply with all applicable federal, state and local
laws, rules and regulations regarding the ownership, operation and transportation of the Wood-Mizer
LX450 sawmill. All Wood-Mizer owners are encouraged to become thoroughly familiar with these
applicable laws and comply with them fully while using the sawmill.
Always properly dispose of all sawing by-products, including sawdust and other debris, coolant, oil,
fuel, oil filters and fuel filters.
Safety instructions are listed in this section by the following operations:
 Blade Handling,
 Sawmill Setup,
 Sawmill Operation,
 Sawmill Maintenance.