Safety & General Information
Sawmill Maintenance
1
1-4 doc041620 Safety & General Information
CAUTION! If the blade breaks during sawmill operation, push
EMERGENCY STOP button to stop the blade motor and wait
10 seconds before you open the blade housing cover.
CAUTION! The sawmill’s work-stand should be equipped with a 4 kg
or bigger dry powder extinguisher.
1.5 Sawmill Maintenance
CAUTION! The up/down screw bellows should completely cover the
screw. If either of the bellows is damaged, replace it immediately.
Before installing the new bellows, clean the up/down screw and nut
thoroughly with extraction naphtha and then grease them.
CAUTION! Reinstall the track wiper so that it lightly touches the track
rail. If the wiper presses too firmly against the rail, it can cause the
power feed to bind.
CAUTION! Never use grease on the mast rails as it will collect
sawdust.
To Next Page
Loading...
