Sawmill Alignment
Adjusting The Saw Head
5
5-10 HDSdoc041620 Sawmill Alignment
5.6 Adjusting The Saw Head
See Figure 5-11. Making these adjustments correctly will give you square cuts and accurate
dimensions across the width of your boards.
1. Check if every four mast rollers touches the track rails. If not, use the mast roller with adjustment (A).
Loosen the locking bolt (B) and lower or raise the roller. Tighten the locking bolt
See Figure 5-12.
2. Using the feed controls, move the saw carriage so that the blade is positioned over the front cross
beam.
3. Adjust blade guides so that they do not touch the blade.
4. Raise the cutting head until the bottom of the blade is 400 mm above the cross beam.
5. Using a tape or ruler check if the distance measured near left and right blade guides is equal(±
1.0 mm).
FIG. 5-12
To Next Page
Loading...
